Datasheet

166 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Main PCBA
c. Ensure that there is very little end-to-end play (detent) in the Take-up Spindle;
adjust the take-up spindle nut as required.
d. Install the two Grooved Splined Cores.
e. Install the one of the O-ring in the front slots on the two cores.
f. Start IDPrint.
g. Select Control > Ribbon Tasks > Find Low Ribbon Torque:
h. Observe the two cores rotate counterclockwise for approximately two minutes.
i. When the motor stops turning, go to the next step.
Core
O-ring
Core