Datasheet

Replacement Procedures
Main PCBA
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 165
5.5.2.2 Adjust Ribbon Torque
The Main PCBA needs to “learn” the amount of voltage required to run the ribbon drive
motor. To do this, you need to perform the Ribbon Torque Adjustment Procedure.
To perform the procedure ensure you have a Clutch Burn-In Tool Kit, a 7/16” nut driver, and
the IDPrint test and adjustment program.
The Clutch Burn-In Tool Kit, P/N: 105927-430, consists of:
Step 1. Find Low Ribbon Torque.
a. Remove the Ribbon.
b. Loosen the payout spindle nut until the Payout Spindle rotates freely.
• Clutch Pulley
Assembly
• Grooved Splined
Cores (2)
• O-rings (2)
Take-up Spindle
Payout Spindle