Datasheet

148 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Troubleshooting
Adjustment Procedures
4.10.4.7 Vertical Offset Adjustment (lower cassette)
Once the front surface offset is consistently acceptable, inspect the back surface patches of the
last few cards to pass through the laminator. Note the offset on the back surface. When flipping
the cards for inspection, keep the mag stripe (if present) toward you.
Referring to diagrams below, correct for vertical offset in the lower laminator using the same
procedure as in Step 1 through Step 11 for the upper cassette; but note that the “reel in”
direction for Step 3 will be clockwise for the lower cassette as it sits in the printer.
Flip the cards left to right (not front to back)
To correct this condition turn the vertical
offset adjust screw counterclockwise
To correct this condition turn the vertical
offset adjust screw clockwise