Datasheet

144 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Troubleshooting
Adjustment Procedures
4.10.4.3 Horizontal Offset Adjust
To access the Laminate Station Adjustment screen, select Start > Printers and Faxes. Right
click on the Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings >
Printer Adjustment > Laminate Station Adjust...
Accurate positioning of the laminate is important for practical and aesthetic reasons. The
laminate must cover the entire image as printed at the time of issuance, thus protecting critical
data with a tamper-deterrent film. If there is no magnetic stripe on the underside, a full width
laminate should be used.
1. Length Adjust (mils) - This is the length of the laminate “patch”. If the patch is too long,
decrease this number, and vice versa.
2. Horizontal Offset (mils) - Adjusts laminate placement on the card.
3. Heater Temperature
This is the set point temperature (i.e., the temperature desired) not the actual temperature.
For actuals, see Sensor Data (Sensor Data on page 71). NOTE: Temperatures are
monitored by thermocouples at the core of the heated rollers. Surface temperatures may
differ significantly.
4. Line Voltage
If Auto is selected, the printer guesses line voltage based on line frequency, assuming that
110V will be @ 60Hz and 230V @ 50Hz. If this is not the case in your locality, the printer
will guess wrong; and you should set the voltage manually.
Caution • Do not set the Heater Temperature above 180°C, or below room temperature.
Caution • Running the printer at 220V, 60Hz in Auto mode may cause premature failure
of the heaters. Running the printer at 110V, 50Hz in Auto mode may cause abnormally
long heat-up time and poor temperature control.