Datasheet

142 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Troubleshooting
Adjustment Procedures
4.10.4 Laminator Adjustments
Correctly positioned top (front) and bottom (back) laminate patches If there is no magnetic
stripe on the underside, a full width patch should be used.
Positioning of the patch is affected by three variables: 1. Horizontal offset (left-right), 2. Skew
(rotation); 3. Vertical offset (up-down). Horizontal offset is a software adjustment. Skew and
vertical offset are mechanical adjustments.
4.10.4.1 Latch Adjustment
The cassette is held in place by two ears on the cassette latch. Using a piece of 1 mil laminate
as a feeler gauge, set the front ear close to, but not touching, the cassette. A hex head screw
(arrowed) sets front-back position of the latch.
Adjust the latch position using a 7/64" hex wrench.
Latch
Adjust
Latch
Ears