Datasheet
Troubleshooting
Adjustment Procedures
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 141
4.10.3.5 Card Position Adjust
This procedure adjusts how far the truck drives into the Flip Station. The adjustment should be
set so that the card is centered in the flip arms (if it is not centered, the truck may have
difficulty removing the card after the flipping action).
To move the card into the Flip Station, select Start > Printers and Faxes. Right click on the
Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings > Control >
Advanced Utilities > Move Carriage. From the drop-down menu, select Flip Position. Press
the Move button.
The card should drive smoothly to rest almost touching the right hand edge of the flip station
base molding. It must not rebound off the edge. The card should land with a gap of between
0.04" and 0.1" (1.0 mm to 2.5 mm). The exact gap is not critical, but it has to be visibly there.
To access the Flip Station Adjustment screen, select Start > Printers and Faxes. Right click on
the Zebra P630i or Zebra P640i printer listing. Select Properties > Device Settings > Printer
Adjustment > Flip Station Adjust...
To move the card further to the right, increase (make less negative) the Card Position Adjust
parameter, and vice versa.
Important • This is a critical adjustment. What can happen if the card position is incorrect?
The truck can depart, leaving the card in the flip arms, or it may drag the card an inch or two
toward the print station, then jam.