Datasheet

Troubleshooting
Adjustment Procedures
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 137
4.10.3 Flip Station Adjustments
4.10.3.1 Flip Station Calibration
This routine determines the number of motor steps it takes for the carrier to descend from the
upper limit position to the lower limit position, that being the carrier’s physical end stop. This
stored number is used to drive the carrier down to the rest position before each and every flip
station action.
Calibration is a one-time setup routine, but is also a useful starting point when diagnosing flip
station problems.
Step 1. Power
OFF, lift the cover, and then push the carrier down to its physical end stop.
When pushing the carrier down, push at the back of the carrier, near the guide shaft.
Do not force!
Step 2. Access the Advanced Utilities screen: select Start > Printers and Faxes. Right
click on the Zebra P630i or Zebra P640i printer listing. Select Properties > Device
Settings > Control > Advanced Utilities.
Step 3. Click the Flip Station Calibration button. This elevates the carrier to the upper limit
position, at which point the motor stops, and the step count is saved in flash
memory. The motor then drives the carrier back down to the lower limit position.