Datasheet

Troubleshooting
Adjustment Procedures
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 131
ae. Observe the panel lights.
af. Adjust the payout spindle nut as required -- if Red, tighten; if Green, loosen.
ag.When the motor stops turning and you are satisfied with the adjustment, go to the
next step.
Step 5. Remove the O-ring and the two Grooved Splined Cores.
Step 6. Load the Ribbon.
Step 7. Power Cycle the Printer.
Note • The panel lights should flash an equal amount of time between Green (Ready) and
Red (Alarm) -- the optimum condition would be Yellow (Media) on all the time.