Datasheet

128 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Troubleshooting
Adjustment Procedures
Step 2. Find High Ribbon Torque
n. Place the Clutch onto the Guide Shaft. Note that you may have to move the
Printhead down to access the Guide Shaft.
o. Place one O-ring around the Clutch (in the rear slot) and around the left core (in
the rear slot).
p. Install the other O-ring in the front slots on the two cores.
q. From the IDPrint screen, select Control > Ribbon Tasks > Find High
Ribbon Torque:
r. Observe the two cores rotate counterclockwise for approximately two minutes.
s. When the motor stops turning, go to the next step.
Step 3. Run Ribbon Motor (Clutch Burn-In)
O-ring
O-ring
Clutch