Datasheet

Troubleshooting
Adjustment Procedures
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 127
g. Ensure that there is very little end-to-end play (detent) in the Take-up Spindle;
adjust the take-up spindle nut as required.
h. Install the two Grooved Splined Cores.
i. Install the one of the O-ring in the front slots on the two cores.
j. Start IDPrint.
k. Select Control > Ribbon Tas ks > Find Low Ribbon Torque:
l. Observe the two cores rotate counterclockwise for approximately two minutes.
m. When the motor stops turning, go to the next step.
Core
O-ring
Core