Datasheet

General Description
Controls and Indicators
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 5
RIBBON button
This button is used to synchronize the ribbon – in other words, to position it correctly under
the print head. If you hold the
RIBBON button down and power up the printer, it toggles on/off
the Ribbon Synchronization feature when the door is closed.
In standard applications, the ribbon type is YMCK, and the back of the card is printed first. In
such cases, pressing the
RIBBON button will advance the color ribbon to bring the leading
edge of the next black panel under the print head.
LAMINATE button
(For the P640i Printer, this applies to the Upper and Lower Laminator; the P630i Printer has
only the Upper Laminator.)
If either (or both) of the laminate transfer rollers is not loaded with a laminate patch, then
pressing the LAMINATE button will correct the condition, provided the cassette is not out of
laminate, and if the cassette latch is closed (locked).
If both transfer rollers are already loaded, the LAMINATE button has no effect.
If you hold the LAMINATE button down and power up the printer, it toggles on/off the
Ribbon Synchronization feature when the printer is powered up.
A standard use of the LAMINATE button is in reloading a transfer roller after removing the
first hand-cut patch of laminate following installation of a fresh roll.
Note • The RIBBON button can be disabled via the printer driver; see Advanced Utilities:
on page 73.
Note • The LAMINATE button can be disabled via the printer driver; see Advanced Utilities:
on page 73.