Datasheet

980584-001 Rev. A Zebra P110i / P110m / P120i Card Printers Service Manual 81
Printhead Replacement
Printhead Installation
Step 1. Record the resistance of the new Printhead Assembly.
Step 2. Connect the 4-wire Color Ribbon Sensor.
Step 3. Connect the printhead data and power cable. Note that the connector is keyed. Use a
flat-blade screwdriver to guide the connector into place.
Step 4. Connect the green ground wire.
Step 5. Push the printhead alignment pin into the alignment hole.
Step 6. Press in and downward, lowering the Printhead Assembly into place.
Step 7. The Printhead installation is complete.
Printhead Resistance
Alignment Pin
Alignment Hole