Datasheet

980584-001 Rev. A Zebra P110i / P110m / P120i Card Printers Service Manual 43
Step 3. Remove cellophane wrapper from card stack.
Step 4. Holding the card deck by the sides, hold it vertically against a flat surface such as a
desktop. If the deck is too thick for your hand to hold it comfortably, use about half
a deck at a time.
Step 5. Push the stack back and forth to an angle of about 45° from vertical, so as to
separate all of the cards.
Step 6. Restore the card stack to its original squared-off condition, and place the cards in
the input hopper.
Note • Static charges and edge burrs from the card die-cutting process can render individual
cards stuck together with significant adhesion force. These cards must be
physically
separated from each other before inserting into the feeder; if not separated, feeding or
printing problems may occur.