Datasheet

16 Zebra P110i / P110m / P120i Card Printers Service Manual 980584-001 Rev. A
2.4 Connecting Power
Step 1. Insert the power supply plug into the power socket, attach the power cord (120VAC
or 230VAC) to the power supply, then plug the power cord in to a grounded
electrical socket of the proper voltage and type.
Step 2. Ensure that the printer’s power switch is in the OFF (O) position.
Caution • Limit electrical power supplied to the printer to 24 VDC. Limit excess current
draw to 16 amps or less, using an associated circuit breaker or other such device. Never
operate the printer in a location where operator, computer, or printer can get wet.
Personal injury could result. The printer must be connected to an earthed electrical
power supply and properly protected against electrical surges and grounding faults. The
power supply pack can only be replaced by the same product from the manufacturer.
Caution • Intermittent or unpredictable operation may occur from unsecured connectors.
If damaged, the power cable must be replaced by an exact equivalent. The socket
should always be easily accessible to power off the printer.
115 VAC
230 VAC