User guide

Important • To change any of these settings, you need to enter the printer password. The

default password is

1234.

Getting Started

Assigning an IP Address

11/12/2009 10/100 Internal Print Server User Guide 14197L-005

5. You can edit any of the following network settings in order to communicate with any

10/100 Internal PS in your network environment. The settings shown below will

sequentially appear after the PRIMARY NETWORK parameter on the control panel.

• ip protocol (GLEANING ONLY, RARP, BOOTP, DHCP, DHCP and BOOTP, ALL,

PERMANENT): The printer menu item

IP PROTOCOL must be set to

PERMANENT if attempting to assign the IP address from the control panel.

• ip address (if initial default setting is 0.0.0.0, after 2 minutes this defaults to

192.168.254.254)

• subnet mask (d

efault setting 255.255.255.0)

• default gatew

ay (default setting of 000.000.000.000)

6. Which model printer do you have?

If you have a(n)… Then…

ZM400 or ZM600 a. Press Select.

b. Press Setup/Exit twice to save your changes and exit the

Setup Mode.

c. The control panel will read PRINTER READY.

Xi4

a. Press Setup/Exit to exit the Setup Mode.

b. Press Next/Save to permanently save your changes.

c. The control panel will read PRINTER READY.