User guide

Getting Started
Defaulting the 10/100 Internal PS
30
14197L-005 10/100 Internal Print Server User Guide 11/12/2009
Defaulting the 10/100 PS on the HC100 Printers
To default the 10/100 Internal PS to factory settings, complete these steps:
1. Press and hold Feed for two seconds.
2. Wait for the three blink sequence of the Error/Status LED.
3. Release Feed.
Defaulting the 10/100 PS on the Xi4 Printers
To default the 10/100 Internal PS to factory settings, complete these steps:
1. From the control panel, press Setup/Exit two times.
2. Press Plus (+) five times.
The control panel will read DEFAULT NET.
3. Press Next/Save to save the change.
The control panel will read PRINTER READY.
Note • Be sure to count the number of LED blinks. The three blink sequence defaults only
the print server parameters while the four blink sequence defaults all of the printer
parameters.