User guide
Table Of Contents
- Contents
- About This Document
- Introduction
- Installation
- Getting Started
- Before You Begin
- Printing a Configuration Label — External ZebraNet 10/100 Print Server
- Printing a Network Configuration Label — Internal ZebraNet 10/100 Print Server and Wireless Print Servers
- Configuration of Wireless Securities
- View Wireless Status through the Control Panel
- Determining the Active Print Server
- Assigning an IP Address on any Print Server
- Setting and Monitoring Alerts on any Print Server
- .
- Checking Print Server Configuration Settings
- Enabling Protocols
- Defaulting ALL Print Servers
- Using WebView
- Using ZebraNet Bridge
- Using a ZPL Command
- Defaulting the ZebraNet 10/100 Print Server on the 105SL, S4M, PAX4 and External Devices
- Defaulting the Wireless Print Server on the S4M
- Defaulting the Print Servers on the ZM400 and ZM600 Printers
- Defaulting the Print Servers on the ZP Series, LP/TLP 2824 Plus, and G-Series Printers
- Defaulting the Print Servers on the HC100 Printers
- Defaulting the Print Servers on the 105SL, PAX4, Xi4, and ZE500 Printers
- Defaulting the Print Servers on the ZT210 and ZT220 Printers
- Defaulting the Print Servers on the ZT230 Printers
- Printing Queues
- Using Printing Protocols
- ZebraLink WebView
- Print Server Web Pages
- Control Panel
- Hardware Troubleshooting
- Troubleshooting the External 10/100 Print Server
- Troubleshooting the Internal ZebraNet 10/100 Print Server
- Troubleshooting the Wireless Print Server
- ZebraNet Bridge Discovery or Configuration Problems
- Unable to Print
- Unable to Configure Device
- HP JetAdmin or HP Web JetAdmin
- Wireless Error Messages
- General Wireless Issues
- Encryption and Authentication Issues
- IP Issues
- Frequently Asked Questions
- Glossary
- Index
63
Getting Started
Setting and Monitoring Alerts on any Print Server
02/28/2012 P1043301-002
Using ZebraNet Bridge
ZebraNet Bridge may be used to set and monitor alerts. Refer to the ZebraNet Bridge
Enterprise User Guide for more detailed information.
Table 16 • ZebraLink Alerts and Destinations
Alert Type Error Condition
ZebraNet
10/100 Print Server
Alerts
• On-line (condition clear)
• Off-line
• Paper out
• Printer error
ZebraLink Alerts
• Media out
• Ribbon out
• Printhead over-temp warning
• Printhead under-temp warning
• Head open
• Power supply over-temp
• Ribbon warning (in direct-thermal mode)
• Rewind full
• Cut error
• Printer paused
• PQ job completed
• Label taken
• Head element out
• ZBI (Zebra BASIC Interpreter) runtime error
• ZBI (Zebra BASIC Interpreter) forced error
• Clean printhead
• Media low
• Ribbon low
• Replace head
• Battery low
• RFID error
• All errors (in RFID printers only)
• All errors (in non-RFID printers only)
• Power on
ZebraLink Alerts
Destinations
Unsolicited Alert messages can be directed to the following
destinations:
• Email (ZebraNet 10/100 Print Server-specific)
• TCP (ZebraNet 10/100 Print Server-specific)
• UDP (ZebraNet 10/100 Print Server-specific)
• SNMP (ZebraNet 10/100 Print Server-specific)
• Serial *
• Parallel *
• USB *
* Available in ZebraNet Bridge