User guide
Table Of Contents
- Contents
- About This Document
- Introduction
- Installation
- Getting Started
- Before You Begin
- Printing a Configuration Label — External ZebraNet 10/100 Print Server
- Printing a Network Configuration Label — Internal ZebraNet 10/100 Print Server and Wireless Print Servers
- Configuration of Wireless Securities
- View Wireless Status through the Control Panel
- Determining the Active Print Server
- Assigning an IP Address on any Print Server
- Setting and Monitoring Alerts on any Print Server
- .
- Checking Print Server Configuration Settings
- Enabling Protocols
- Defaulting ALL Print Servers
- Using WebView
- Using ZebraNet Bridge
- Using a ZPL Command
- Defaulting the ZebraNet 10/100 Print Server on the 105SL, S4M, PAX4 and External Devices
- Defaulting the Wireless Print Server on the S4M
- Defaulting the Print Servers on the ZM400 and ZM600 Printers
- Defaulting the Print Servers on the ZP Series, LP/TLP 2824 Plus, and G-Series Printers
- Defaulting the Print Servers on the HC100 Printers
- Defaulting the Print Servers on the 105SL, PAX4, Xi4, and ZE500 Printers
- Defaulting the Print Servers on the ZT210 and ZT220 Printers
- Defaulting the Print Servers on the ZT230 Printers
- Printing Queues
- Using Printing Protocols
- ZebraLink WebView
- Print Server Web Pages
- Control Panel
- Hardware Troubleshooting
- Troubleshooting the External 10/100 Print Server
- Troubleshooting the Internal ZebraNet 10/100 Print Server
- Troubleshooting the Wireless Print Server
- ZebraNet Bridge Discovery or Configuration Problems
- Unable to Print
- Unable to Configure Device
- HP JetAdmin or HP Web JetAdmin
- Wireless Error Messages
- General Wireless Issues
- Encryption and Authentication Issues
- IP Issues
- Frequently Asked Questions
- Glossary
- Index
02/28/2012 P1043301-002
Index
000.000.000.000
troubleshooting
142
10/100 print server settings
access
110
192.168.254.254
troubleshooting
142
A
access
10/100 print server settings
110
access point
troubleshooting problems
140
active device selection
56
active print server
determine
55
IP address
55
network configuration label
55
selecting primary network device
56
adaptor for compact flash card
37
address administration protocols
support
16
advanced setup
WebView
97
alerts
set using WebView
64
set using ZebraNet Bridge
63
setting and monitoring
62
ZebraLink
62
assign an IP address
58
from printer control panel (LCD)
59
from ZebraNet Bridge
58
using gleaning
61
using static route
60
via telnet
60
with DHCP
58
authentication
troubleshooting
141
B
browser
configuration settings
67
browser support
requirements
16
BSD-Style print queue
configuration
80
C
calibration
WebView
96
compact flash card
install
37