User guide
Table Of Contents
- Contents
- About This Document
- Introduction
- Installation
- Getting Started
- Before You Begin
- Printing a Configuration Label — External ZebraNet 10/100 Print Server
- Printing a Network Configuration Label — Internal ZebraNet 10/100 Print Server and Wireless Print Servers
- Configuration of Wireless Securities
- View Wireless Status through the Control Panel
- Determining the Active Print Server
- Assigning an IP Address on any Print Server
- Setting and Monitoring Alerts on any Print Server
- .
- Checking Print Server Configuration Settings
- Enabling Protocols
- Defaulting ALL Print Servers
- Using WebView
- Using ZebraNet Bridge
- Using a ZPL Command
- Defaulting the ZebraNet 10/100 Print Server on the 105SL, S4M, PAX4 and External Devices
- Defaulting the Wireless Print Server on the S4M
- Defaulting the Print Servers on the ZM400 and ZM600 Printers
- Defaulting the Print Servers on the ZP Series, LP/TLP 2824 Plus, and G-Series Printers
- Defaulting the Print Servers on the HC100 Printers
- Defaulting the Print Servers on the 105SL, PAX4, Xi4, and ZE500 Printers
- Defaulting the Print Servers on the ZT210 and ZT220 Printers
- Defaulting the Print Servers on the ZT230 Printers
- Printing Queues
- Using Printing Protocols
- ZebraLink WebView
- Print Server Web Pages
- Control Panel
- Hardware Troubleshooting
- Troubleshooting the External 10/100 Print Server
- Troubleshooting the Internal ZebraNet 10/100 Print Server
- Troubleshooting the Wireless Print Server
- ZebraNet Bridge Discovery or Configuration Problems
- Unable to Print
- Unable to Configure Device
- HP JetAdmin or HP Web JetAdmin
- Wireless Error Messages
- General Wireless Issues
- Encryption and Authentication Issues
- IP Issues
- Frequently Asked Questions
- Glossary
- Index
Hardware Troubleshooting
Troubleshooting the External 10/100 Print Server
132
P1043301-002 02/28/2012
The Status LED is solid
red for more than 30
seconds
The external ZebraNet
10/100 Print Server has failed the
POST.
If the failure is not severe, the external
ZebraNet 10/100 Print Server attempts to
print a configuration label on the printer.
1. Turn the printer off (O), wait 10
seconds, then turn the printer on
(I).
2. If the external ZebraNet 10/100 Print
Server still fails the POST, the print
server has a hardware problem that can
only be fixed by replacing or returning
the unit.
3. Contact Repair for repair or replacement
information.
A failed POST may be a
connection to a malfunctioning
external ZebraNet 10/100 Print
Server device.
The Status LED is
alternately flashing red
and green for longer
than 2 minutes
The external ZebraNet
10/100 Print Server is in firmware-
download mode.
This means it is waiting for new
firmware data to be sent before it
continues normal functioning.
• If the external ZebraNet 10/100 Print
Server was purposely put into
firmware-download mode, finish the
download with the proper update utility.
Visit the Zebra Web site at
http://www.zebra.com/utilities to
download this utility.
• If the external ZebraNet 10/100 Print
Server was not put into
firmware-download mode or if you wish
to exit this mode, default the unit.
Follow the instructions in Defaulting the
ZebraNet 10/100 Print Server on the
105SL, S4M, PAX4 and External
Devices on page 74.
Table 22 • External ZebraNet 10/100 Print Server Issues and Solutions (Continued)
Issue Possible Cause Recommended Solution