User guide

Operations
Load Media in Rewind Mode
58
11342L-003 Rev. A 105SL User Guide 7/10/07
To load media in Rewind mode, complete these steps:
1. Is the rewind plate installed as shown in Figure 13?
2. Set the printer to Rewind mode. See Select Print Mode on page 89 for instructions.
3. Insert media into the printer. See Insert Media into the Printer on page 39 for instructions.
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
If… Then…
Yes Continue with the next step
No
a. Remove the rewind plate from its storage location in front of the print
mechanism inside the media compartment.
b. Invert the rewind plate so that the top lip (1) and the adjustable hook
plate (
2) point down.
c. Engage the top lip and the adjustable hook plate into the two mounting
slots on the side plate of the print mechanism. Slide in the rewind plate as
far as it will go.
1
2