User guide

Printer Setup

Connect the Printer to a Power Source

11342L-003 Rev. A 105SL User Guide 7/10/07

Connect the Printer to a Power Source

The AC power cord must have a three-prong female connector on one end that plugs into the

mating AC power connector at the rear of the printer. If a power cable was not included with

your printer, refer to Power Cord Specifications on page 32.

To connect the printer to a power source, complete these steps:

1. Toggle the printer power switch to the off (O) position.

2. See Figure 5. Plug the power cord into the AC power connector (1) on the rear of the

printer.

Figure 5 • Power Connection

3. Plug the other end of the power cord into a power outlet near the printer.

Caution • For personnel and equipment safety, always use an approved three-conductor

power cord specific to the region or country intended for installation. This cord must use an

IEC 320 female connector and the appropriate region-specific three-conductor grounded

plug configuration.

Power switch

AC power connector