User's Manual Part 3

Routine Maintenance
Cleaning Schedule and Procedures
132
P1009874-001 Xi4 User Guide 2/23/09
Clean the Snap Plate
Clean the snap plate when label adhesive or a label is stuck to the underside. Figure 20 shows
the location of the snap plate.
Figure 20 • Snap Plate Location
To clean the snap plate, complete these steps:
1. See Figure 20. Insert a small-blade screwdriver or similar tool into the loop on the left side
of the snap plate.
2. Gently lift the left side of the snap plate.
3. Insert a small-blade screwdriver or similar tool into the loop on the right side of the snap
plate.
4. Gently lift the right side of the snap plate.
5. Remove the snap plate from the printer.
6. Clean the snap plate with cleaning solvent and a soft cloth.
7. To reinstall the snap plate, insert the two tabs on the bottom of the snap plate into the two
slots of the media path.
8. Slide the snap plate toward you.
9. Press down on the loops to lock the snap plate into place.
1
Left loop
2
Snap plate
3
Right loop
1
2
3