User's Manual Part 2

Operations

Adjust Media Sensors

2/23/09 Xi4 User Guide P1009874-001

Upper Media Sensor—Outside Half of Media

To adjust the upper media sensor for the outside half of the media, complete

these steps (all models except the 220Xi4):

1. Remove the ribbon (if ribbon is used).

2. Locate the upper media sensor adjustment screw (1). The upper media sensor eye is

directly below the adjustment screw head.

3. Using a thin, flat-blade screwdriver, loosen and then remove the upper media sensor

adjustment screw.

4. Lift the upper media sensor assembly from the slot, and move it and the wire cover to the

outside slot. Carefully pull the wires through the cable tie. You may need to set aside the

sensor wire cover if the adjustment is too far to the outside.

5. Replace and slightly tighten the adjustment screw.