User Manual

MPA Project Document 70-147018-01 REV A

20110307-A

Confidential Material – Disclosure Strictly Prohibited.

This device is intended only for OEM integrators under the following

conditions:

1) The antenna must be installed such that 20 cm is maintained between

the antenna and users, and

2) The transmitter module may not be co-located with any other

transmitter or antenna,

3) For all products market in US, OEM has to limit the operation channels

in CH1 to CH11 for 2.4G band by supplied firmware programming tool.

OEM shall not supply any tool or info to the end-user regarding to

Regulatory Domain change.

As long as 3 conditions above are met, further transmitter test will not be

required. However, the OEM integrator is still responsible for testing their

end-product for any additional compliance requirements required with this

module installed

IMPORTANT NOTE: In the event that these conditions can not be met (for

example certain laptop configurations or co-location with another transmitter),

then the FCC authorization is no longer considered valid and the FCC ID

can not be used on the final product. In these circumstances, the OEM

integrator will be responsible for re-evaluating the end product (including the

transmitter) and obtaining a separate FCC authorization.

• End Product Labeling

This transmitter module is authorized only for use in device where the

antenna may be installed such that 20 cm may be maintained between the

antenna and users. The final end product must be labeled in a visible area

with the following: “Contains FCC ID: UZ7XWING1”.

• Manual Information To the End User

The OEM integrator has to be aware not to provide information to the end

user regarding how to install or remove this RF module in the user’s manual

of the end product which integrates this module.

The end user manual shall include all required regulatory

information/warning as show in this manual.