User's Manual Part 2

Accessories 6 - 27
RS4000 Scanner
To connect the RS4000 scanner to the WT6000:
1. Connect the scanner interface cable to the WT6000 interface connector. If the WT6000 is mounted on the arm,
connect the cable to the interface connector closest to the wrist.
Figure 6-29 Connecting Scanner to WT6000
2. If using the extended cable configuration, route the scanner cable up to the shoulder and down to the hand that
the scanner mounts on. Attach two cable clips to clothing and secure cable to cable clip.
Figure 6-30 Cable Clip Installation
3. Rotate the trigger assembly to the correct position for the hand that the scanner mounts to.
NOTE There are two scanner configurations available. The short cable configuration connects the scanner to the
WT6000 mounted on the arm. The extended cable configuration connects the scanner to the WT6000
mounted on the hip.
Cable Connector
Interface Connector