User's Manual

User Guide
___________________________________________________________________________________________________________________
_________________________________________________________________________________________________________________
58
User Guide, WherePort IV D1300 REV A
© Copyright WhereNet, Corp. 2008 WhereNet Confidential
12.5.11. EXE
EXE n<cr>
Send message to magnetic field generator and the flash memory.
12.5.12. Sequence Mode
Set number of WherePort IV in the chain for sequencing mode.
CMW n<cr>
Where n is a value of 1 through 15. A value of 0 disables sequence mode. A value of 1 means that there
is a master and 1 slave.
Example:
CMW 2<cr>
Sets the number of WherePort IVs in the chain to 3, one master and 2 slaves.
12.5.13. Sequence Mode Message Number
CMC n<cr>
N is a value from 0 to 15. Sets the number of messages to send for each WherePort IV in sequence mode.
0 disables sequencing mode.
The dwell time (how long it takes to send the programmed number of messages) increases as the number
of messages increases. Table 1 lists the dwell times for the available combinations of message lengths
and message numbers. The types are listed in the left column. The number of messages are listed in the
body of the table. The dwell time is shown in the header column.
Table 1 Dwell Time (in seconds)
Message
Type
0.2 0.5 1.0 2.0 3.0 4.0 5.0 10 15 20
1
25 64 128 255
2
12 30 60 120 181 255
3
8 20 41 82 123 164 205
4
3 7 14 27 41 55 68 137 205 255
5
3 7 14 27 41 55 68 137 205 255
6
3 7 14 27 41 55 68 137 205 255