User's Manual

User Guide
___________________________________________________________________________________________________________________
_________________________________________________________________________________________________________________
57
User Guide, WherePort IV D1300 REV A
© Copyright WhereNet, Corp. 2008 WhereNet Confidential
Example:
CNT 4<cr>
Sets the blink count to 4.
12.5.8. Interval
Set the WherePort IV response blink interval (44 bit message only ) where n is 0 to 7.
INT n<cr>
12.5.9. Trigger
Set the re-trigger response (44 bit message only).
TRG n<cr>
Where n is a value 0 through 15.
Example:
TRG 4<cr>
Sets the re-trigger response to 10 sec.
12.5.10. Data
Set the 96 bit data payload (144 bit message only).
DAT [string]<cr>
String of 24 ASCII-HEX characters; set the 96 bit data payload (144 bit message only).
String of 22 ASCII-HEX characters: set the 96 bit data payload, payload CRC automatically calculated
(144 bit message only).
Example:
DAT string<cr>
A string of 24 ASCII-HEX characters to set the 96-bit data payload of the WherePort IV.