User's Manual
Table Of Contents
12 : UWD-3100 DartWand Software User Guide 1.0
Configuring tags
Start the DartWand software
From the Blink list, select On or OFF to enable or disable UWB blinks, or accept the current
setting.
3 Position the tag close to the UWD-3100 DartWand hardware and click Go.
The status report adds a record for each tag. The Config tab displays the number of acknowledged
tags at the bottom right. The Configuring Tags dialog box indicates the configuration progress.
4 In the Configuring Tags dialog box, do one of the following:
If all tags were configured successfully, the dialog box displays a green check mark and the
success rate, in percent. In this case, click OK.
If one or more tags failed during the configuration, the dialog box turns yellow and displays a list
of the tags that failed. In this case, reposition the tags or the DartWand, and then click Retry.
When all tags were configured successfully, click OK.
In This Section
Create a tag list ................................................................................................. 13