User's Manual

___________________________________________________________________________
WhereWand II User’s Guide
___________________________________________________________________________ 59
WhereWand II User’s Guide D1258 rev A
© Copyright WhereNet, Corp. 2002
WhereNet Confidential
The user can press <Y> to send the properties to the Location Sensor or hit <Esc>
to cancel and change the settings again. It takes 10 seconds to transmit all the
properties from the WhereWand to the Location Sensor. The screen show in
figure 49 is displayed while the WhereWand is sending the properties. The LED
on the Location Sensor will flash on and off at a 1 second rate if the link is
functional and the command is being received correctly.
Figure 49: Location Sensor Sending
6.3 Rebooting the Location Sensor
Rebooting the Location Sensor will take it out of commission until it completes
the reboot. This can take several minutes so a confirmation screen is presented as
shown in figure 50.
Important: The reboot message will be transmitted for 15 seconds. Pressing a
key will stop the transmission.