User's Manual

___________________________________________________________________________

WhereWand II User’s Guide

___________________________________________________________________________ 56

WhereWand II User’s Guide D1258 rev A

WhereNet Confidential

6.1 Flashing Location Sensor LEDs

Pressing <F1> will cause the WhereWand to transmit the messages to flash the

Location Sensor LEDs. This is useful in verifying that the user is communicating

with the correct Location Sensor and that the link is functional. The WhereWand

will automatically stop after 30 seconds, or the user can press <Enter> to stop the

test at any time. Figure 44 shows the LED flash screen.

Figure 44: Location Sensor LED Flash

6.2 Configuring the Location Sensor Network Properties

Pressing <F2> will allow the user to set the network properties of the Location

Sensor. First the user can select to enable or disable DHCP, as shown in figure 45.