User's Manual

___________________________________________________________________________
WhereWand II User’s Guide
___________________________________________________________________________ 53
WhereWand II User’s Guide D1258 rev A
© Copyright WhereNet, Corp. 2002
WhereNet Confidential
5.4 Read WherePort Configuration
When the user selects <F2> from the WherePort utilities screen, the WhereWand
will read and display the WherePort configuration. The cable must be connected
between the WhereWand and the WherePort. Figure 41 shows the read WherePort
configuration screens.
Figure 41: Read WherePort Configuration
6 LOCATION SENSOR UTILITIES
The user enters the WherePort utilities by press <F3> from the WhereWand
utilities screen shown in figure 3. The Location Sensor utilities allow the user to
 Perform link check by flashing the LEDs on the Location Sensor
 Reconfigure the Location Sensor network parameters
 Re-boot the Location Sensor.