User's Manual

___________________________________________________________________________
WhereWand II User’s Guide
___________________________________________________________________________ 51
WhereWand II User’s Guide D1258 rev A
© Copyright WhereNet, Corp. 2002
WhereNet Confidential
WherePort sending these messages will respond using the new parameters
included in the WherePort message. Since these parameters are written to the tag
configuration, they are identical to the parameters described in the tag utilities
section of this document.
CAUTION: These changes are permanent and will affect the way the tag will
respond to all WherePorts until the tag is re-configured with either the
WhereWand or another configuring WherePort.
The WherePort Blink Count is described in section 4.2.2. The WherePort Blink
interval is described in section 4.2.3. The WherePort Retrigger is described in
section 4.2.4. The screens are also shown in section 4.2, figures 12 through 14.
5.3.7 Configure WherePort Data Buffer
Selecting <I> or <J> from the set WherePort configuration screen allows the user
to enter the data sent in WherePort message length 143. The buffer is 12-bytes
long and is broken into 2 parts for display purposes. The data is entered in
hexadecimal (12 characters per half). Figure 40 shows the screen for entering
buffer data.