User's Manual

___________________________________________________________________________
WhereWand II User’s Guide
___________________________________________________________________________ 44
WhereWand II User’s Guide D1258 rev A
© Copyright WhereNet, Corp. 2002
WhereNet Confidential
5.3.1 Configure WherePort ID
Selecting <A> WP ID from the set WP config screen allows the user to set the
WherePort ID. Any ID from 256 to 32,767 can be used, but it is important to keep
from repeating the ID of nearby WherePorts to avoid retrigger issues. Figure 34
shows the WherePort ID screen.
Figure 34: WherePort ID
5.3.2 Configure WherePort Message Length
Selecting <B> from the set WherePort configuration screen allows the user to set
the message length, which defines the message type. There are 4 different
message lengths supported. The message length defines which of the other
WherePort configuration parameters are applicable. Table 3 outlines the
applicable parameters versus the message length.