User's Manual

___________________________________________________________________________
WhereWand II User’s Guide
___________________________________________________________________________ 29
WhereWand II User’s Guide D1258 rev A
© Copyright WhereNet, Corp. 2002
WhereNet Confidential
Figure 15: Custom Configuration WP Retrigger
4.2.5 Custom Configuration Switch Blink Count
Selecting <E> Sw Count from the custom configuration screen 1 will allow the
user to set the number of blinks the tag sends in response to a level change on one
of its switch or telemetry inputs. Switch event blinks can be disabled by selected
<F1> 0. The tag can send up to 15 blinks in response to a switch event message.
As soon as the user selects a blink count, the WhereWand application will return to
custom configuration screen 2 to allow another parameter to be selected and
modified. The user can press <Enter> to go between the blink count pages, or
<ESC> to return to the previous menu. Figure 16 shows the available counts.
This configuration parameter applies only to tags with ID greater than 17,000,000.