User's Manual

___________________________________________________________________________
WhereWand II User’s Guide
___________________________________________________________________________ 21
WhereWand II User’s Guide D1258 rev A
© Copyright WhereNet, Corp. 2002
WhereNet Confidential
4.2 Custom Configuration
Select Custom <F5> from the SET CONFIG screen will allow the user to
configure all of the available tag parameters to meet unique application
requirements. Table 1 describes each of the configurable parameters that the user
can access through the screens shown in figures 8 and 9. Figure 10 shows the tag
ID entry screen. The user can move between screens shown in figures 8 through
10 using <Enter> and <Esc>. Once the user has changed the desired parameter
and presses <Enter> the WhereWand will bring up the tag ID entry screen. The
user can either scan the tag bar code with the laser scanner on the WhereWand, or
manually type the tag ID using the WhereWand keypad and then hitting <Enter>.
The WhereWand will then open the tag communications link and send the custom
configuration. Once the tag has been successfully configured, the WhereWand
will indicate the status of the communications.
Figure 8: Custom Config Screen 1