User's Manual

Chapter 2: Software Installation
6881011Y52-D January 2007
2-6
16
The Select Options dialog box will be displayed as shown in Figure 2-9. This installation screen allows
the user to view the ReadMe file during the installation and to run MeshTray immediately following
installation. Click on the Next button to proceed with the installation process.
Figure 2-9 Software Installation Dialog Box – Select Options
17
If selected, the ReadMe file will be displayed. Review the contents of the file and then dismiss the
dialog box by clicking on the X located in the upper right corner of the dialog.
You MUST close the ReadMe file to complete the installation.
18 From the MOTOMESH Installed Successfully dialog click on the Finish button to exit.
Be sure to close the ReadMe file (if you elected to view it in the earlier steps), otherwise the dialog
shown below will not be displayed.
Figure 2-10 MOTOMESH Setup - MOTOMESH Installed Successfully (XP)