User's Manual

MEA PWR User’s Guide
manager. The network manager can also limit the user-selectable schemes or force a specific
scheme. Devices in each of these schemes can interoperate and communicate with each other,
so long as the assigned addresses do not conflict and are mutually routable.
3.1.2.5 Setting the User Supplied IP Address
In order to set the user-supplied IP address for the EWR, the User-Supplied radio button must
be selected. At that point, the user may enter an IP address, subnet mask consistent with the
existing network. The user should also enter the IP address of the default gateway and DNS
server, as well as enter the domain name.
Note that this configures the user-supplied address for the EWR device. To configure addresses
for ethernet clients, please refer to the description of the External Device Provisioning frame of
this web page in Section 3.2
.
A similar screen will be displayed for the access account (the web page will indicate Normal
User Login). Normal users can change only those settings for which they have system
privileges.
When the desired configuration has been completed, click on the Apply button on the Device
Addressing panel on the Device Administration Configuration Page. You will be prompted to
verify that the changes to the configuration are correct before the changes are actually applied.
Figure 3-5. Configuration Change Verification
When you click on the OK button, the configuration will be saved in Flash. The System Settings
Have Been Saved message on the System Update Save Completed page will then confirm the
changes have been saved.
13