User's Guide

MeshNetworks
8
Connect the Antenna Assembly
Complete the following procedure to connect the Antenna Assembly (Knuckle or Pigtail type) to
the WMC6300 for use in a standard laptop computer.
WARNING
Always eject card when not in use.
1. Locate the Antenna and insert the connector into the WMC6300 antenna
port as shown in Figure 10.
Note: The connector will snap into place when fully inserted.
Figure 10. Attach Antenna to the WMC6300
Warning
Use only FCC approved antenna.
Use of other antennas is prohibited and violates FCC regulations.
Never use the WMC6300 with the Antenna disconnected from the Card.
Insert the WMC6300 Wireless Modem Card
Complete the following procedure to install the WMC6300 Wireless Modem Card in the
computer.
1. Locate an available Type II PCMCIA card slot in the PDA. If necessary,
remove the slot dust cover from the slot.