Installation Guide
Table Of Contents
- Overview
- Description of the MEA System
- Introduction
- Subscriber Devices (SDs)
- Wireless Routers (WRs)
- Intelligent Access Points (IAPs)
- VMM6300 - Vehicle Mounted Modem
- EWR6300 - Enhanced Wireless Router
- PWR6300 Portable Wireless Router
- Mobile Internet Switching Controller (MiSC)
- Operational View of the MEA System
- Network Architecture
- Unified Modes of Operation
- Quality of Service (QoS) and User Priority Features
- Setup and Installation
- Subscriber Device (SD)
- Intelligent Access Point (IAP)
- Wireless Router (WR)
- Mobile Internet Switching Controller (MiSC)
- Upgrade MiSC/DHCP Configuration (optional)
- MAC Address Tables
- Site Selection/Deployment Guidelines
- Customer Service Information
- License and Warranty Information
- FCC Regulatory Information
- Safety Information for the MEA Products
- Safety Certification
MEA Setup and Installation
Backup Interface Subnet Prefix – Allows an alternate subnet prefix to be used for the IAPs in the
event that the 10.x.x.x subnet is already in use.
Click the Apply button to save the changes, or click the Cancel button to delete any changes. If
the Apply button is selected, a confirmation window will appear as in Figure 37. Click on the
OK button to continue or select Cancel to terminate the procedure.
Figure 37. System Settings Confirmation Message
If the Apply button is selected, the new values will be saved and Figure 38 will be displayed.
The changes will not take effect until the device is reset. Select the Finished button to navigate
to the Device Reset option.
Figure 38. System Settings Saved Message
33