Installation Guide
Table Of Contents
- Overview
- Description of the MEA System
- Introduction
- Subscriber Devices (SDs)
- Wireless Routers (WRs)
- Intelligent Access Points (IAPs)
- VMM6300 - Vehicle Mounted Modem
- EWR6300 - Enhanced Wireless Router
- PWR6300 Portable Wireless Router
- Mobile Internet Switching Controller (MiSC)
- Operational View of the MEA System
- Network Architecture
- Unified Modes of Operation
- Quality of Service (QoS) and User Priority Features
- Setup and Installation
- Subscriber Device (SD)
- Intelligent Access Point (IAP)
- Wireless Router (WR)
- Mobile Internet Switching Controller (MiSC)
- Upgrade MiSC/DHCP Configuration (optional)
- MAC Address Tables
- Site Selection/Deployment Guidelines
- Customer Service Information
- License and Warranty Information
- FCC Regulatory Information
- Safety Information for the MEA Products
- Safety Certification
MeshNetworks
System Settings Tab
The System Settings Tab is shown in Figure 36.
Figure 36. MEA Device Administration System Settings Tab
The System Settings tab allows the network operator to change the following values:
HAS IP Address – (Hardware Authentication Server) Network host from which authentication is
requested.
HAS Port Number – Port number on the Network host from which authorization is requested (a
value of zero causes the IAP to not request authentication).
RDATE Server IP Address – Network host from which time and date information is retrieved.
IPRS IP Address - (Internet Protocol Resolution Server) Network host that the IAP relays
IP/MAC address information to
IPRS TCP Port - Port number on the Network host which the IAP relays IP/MAC address
information
IPRS UDP Port - Port number on the Network host that the IAP responds to when asked for
unknown address information
32