Installation Guide
Table Of Contents
- Overview
- Description of the MEA System
- Introduction
- Subscriber Devices (SDs)
- Wireless Routers (WRs)
- Intelligent Access Points (IAPs)
- VMM6300 - Vehicle Mounted Modem
- EWR6300 - Enhanced Wireless Router
- PWR6300 Portable Wireless Router
- Mobile Internet Switching Controller (MiSC)
- Operational View of the MEA System
- Network Architecture
- Unified Modes of Operation
- Quality of Service (QoS) and User Priority Features
- Setup and Installation
- Subscriber Device (SD)
- Intelligent Access Point (IAP)
- Wireless Router (WR)
- Mobile Internet Switching Controller (MiSC)
- Upgrade MiSC/DHCP Configuration (optional)
- MAC Address Tables
- Site Selection/Deployment Guidelines
- Customer Service Information
- License and Warranty Information
- FCC Regulatory Information
- Safety Information for the MEA Products
- Safety Certification
MeshNetworks
Network Setup Description
The basic MiSC hardware configuration is shown in Figure 15.
Figure 15. Basic MiSC Configuration
The following describes the parameters for setting up the network:
• All MEA wireless devices must be within the same subnet.
• MEA currently uses the non-routable 10.x.x.x (8 bit) subnet as defined in RFC 1918.
• The IAPs, WRs, and SDs will use DHCP to obtain an IP address, the default
configuration returns a 10.x.x.x address.
Subnet information may be modified by editing the DHCP configuration file (dhcpd.conf) located
on the MeshManager Server.
14