Installation Guide
Table Of Contents
- Overview
- Description of the MEA System
- Introduction
- Subscriber Devices (SDs)
- Wireless Routers (WRs)
- Intelligent Access Points (IAPs)
- VMM6300 - Vehicle Mounted Modem
- EWR6300 - Enhanced Wireless Router
- PWR6300 Portable Wireless Router
- Mobile Internet Switching Controller (MiSC)
- Operational View of the MEA System
- Network Architecture
- Unified Modes of Operation
- Quality of Service (QoS) and User Priority Features
- Setup and Installation
- Subscriber Device (SD)
- Intelligent Access Point (IAP)
- Wireless Router (WR)
- Mobile Internet Switching Controller (MiSC)
- Upgrade MiSC/DHCP Configuration (optional)
- MAC Address Tables
- Site Selection/Deployment Guidelines
- Customer Service Information
- License and Warranty Information
- FCC Regulatory Information
- Safety Information for the MEA Products
- Safety Certification
MEA Setup and Installation
Record MAC Address of the MWR6300
The transceiver MAC address is recorded on the label located on the antenna end of the
MWR6300 as shown in Figure 13.
Record this number in Section 4 - MAC Address Tables
, because it will be required later to
configure and test the device.
Figure 13. MWR6300 Identification Label
MWR6300 Assembly
Figure 14 shows the external; connection points on a MWR6300 box.
Test Port
Figure 14. MWR6300 External Connection Points
Assemble the WR using the following procedure:
1.
2.
3.
If desired, mount the WR box using the enclosed bracket. Refer to the procedure in the
IAP assembly section of this document.
Insert the Antenna into the N-type Connector on the top of the box, and rotate to close.
Insert the Power Plug into the 4-pin Connector.
11