Installation Guide
Table Of Contents
- Overview
- Description of the MEA System
- Introduction
- Subscriber Devices (SDs)
- Wireless Routers (WRs)
- Intelligent Access Points (IAPs)
- VMM6300 - Vehicle Mounted Modem
- EWR6300 - Enhanced Wireless Router
- PWR6300 Portable Wireless Router
- Mobile Internet Switching Controller (MiSC)
- Operational View of the MEA System
- Network Architecture
- Unified Modes of Operation
- Quality of Service (QoS) and User Priority Features
- Setup and Installation
- Subscriber Device (SD)
- Intelligent Access Point (IAP)
- Wireless Router (WR)
- Mobile Internet Switching Controller (MiSC)
- Upgrade MiSC/DHCP Configuration (optional)
- MAC Address Tables
- Site Selection/Deployment Guidelines
- Customer Service Information
- License and Warranty Information
- FCC Regulatory Information
- Safety Information for the MEA Products
- Safety Certification
MEA Setup and Installation
3. Highlight Internet Protocol (TCP/IP) in the Components window.
4. Click on the Properties button.
5. Click on the Advanced button.
6. Click on the DNS tab
7. Click on the DNS Add button.
8. Enter the DNS Server IP Address provided by the network administrator and then click
the Add button.
9. Click the OK button to close the Advanced TCP/IP Settings windows.
10. Click the OK button to close the Internet Protocol (TCP/IP) Properties windows.
11. Click the OK button to close the Local Area Connection Properties windows.
12. Click the Close button to close the Local Area Connection Status window.
This configuration should remain in the Windows 2000 host.
Instructions to setup a Windows XP host:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
1.
Click on Start/Control Panel/Network and Dial-up Connections/Local Area Connection
Right click on the Local Area Connection Corresponding to the Wireless Modem Card
and select Properties from the pop up menu.
Highlight Internet Protocol (TCP/IP) in the Components window.
Click on the Properties button.
Click on the Advanced button.
Click on the DNS tab
Click on the DNS Add button.
Enter the DNS Server IP Address provided by the network administrator and then click
the Add button.
Click the OK button to close the Advanced TCP/IP Settings windows.
Click the OK button to close the Internet Protocol (TCP/IP) Properties windows.
Click the OK button to close the Local Area Connection Properties windows.
Click the Close button to close the Local Area Connection Status window.
This configuration should remain in the Windows XP host.
Installing the WMC6300 Software for Windows 2000
The MEA WMC6300 Wireless Modem Card User’s Guide for Windows 2000 provides complete
step-by-step instructions for use during the installation and configuration of the WMC6300. The
following is an abbreviated version of the installation process.
Note: Please install the MEA Software before you insert the WMC6300 card.
Complete the following procedure to install the WMC6300 software and drivers:
Insert the WMC6300 Software and Documentation CD into the computer’s CD-ROM
drive.
3