User's Guide

MEA WMC6300 Windows User’s Guide
11
Installing MEA Software with a Windows 2000 Operating System
The following procedure outlines the installation of the MEA software on a typical Windows 2000
platform. Some of the steps may vary slightly based on the configuration of the individual
computers.
NOTE: Windows 2000 clients should install the MEA Software before inserting the WMC6300
card.
Complete the following procedure to install the MEA software:
1. Insert the MEA Software and Documentation CD into the CD-
ROM drive.
2. If the installation program does not start automatically, open the
Windows Start. Click on Run then type the following into the
dialog box:
d:setupmeaclient.exe
where d: specifies the CD-ROM drive and click the “OK” button.
3. The MEA Setup program will be displayed as shown in Figure 12.
4. Click the Next button to continue the installation process.
Figure 12. MEA Setup - Installer Setup Dialog Box
5. The License Agreement dialog box will be displayed. Please review the
End User License Agreement. Use the scroll bar located at the right side
of the dialog box to display the complete text message.
NOTE: If you do not agree with the terms of the license agreement, click on Cancel and
the installation will be terminated.