User's Guide

MEA WMC6300 Windows User’s Guide
5
Installing MEA Software with a Windows XP Operating System
The following procedure outlines the installation of the MEA software on a typical Windows XP
platform. Some of the steps may vary slightly based on the configuration of the individual
computers.
NOTE: Windows XP clients should install the MEA Software before inserting the WMC6300
card.
Complete the following procedure to install the MEA software:
1. Insert the MEA Software and Documentation CD into the CD-ROM drive.
2. If the installation program does not start automatically, open the Windows
Startmenu. Click on Run then type the following into the dialog box:
d:setupmeaclient.exe
where d: specifies the CD-ROM drive and click the “OK” button.
3. Click the “Next” button to continue the installation process.
4. The MEA Setup dialog box will be displayed as shown in Figure 3.
5. Click the Next button to continue the installation process.
Figure 3. MEA Setup - Welcome Dialog Box
6. The License Agreement dialog box will be displayed as shown in Figure
4. Please review the End User License Agreement. Use the scroll bar
located at the right side of the dialog box to display the complete text
message.
NOTE: If you do not agree with the terms of the license agreement, click on Cancel and
the installation will be terminated.