User's Manual
Table Of Contents
- Vehicle Mounted Modem
- Installation Requirements
- Installing the MEA Vehicle Mounted Modem
- Device Administration: Configuring the VMM Devices
- External Device Provisioning
- Infrastructure Requirements
- License and Warranty Information
- FCC Regulatory Information
MEA VMM User’s Guide
2.2 Record MAC Address of the VMM6300
The transceiver and SBC (Ethernet) MAC addresses are recorded on the label located on front
side of the VMM unit.
Record these numbers in the MAC Address Table in Section 3.3.1, because they will be
required later to configure and provision the device.
Figure 2-1 VMM6300 Identification Label
2.3 VMM6300 Assembly
The VMM6300 Assembly shows the external connection points on a VMM6300 box.
N-Type
Antenna
Power
Reset
Power
Connect
Ethernet
(Crossover MDI-X)
Figure 2-2. VMM External Connection Point
3