User's Manual

WMC6300 Windows 2000 User’s Guide
Connect the Antenna Assembly (Laptop Computer)
Complete the following procedure to connect the Antenna Assembly to the
WMC6300, for use in a standard laptop computer.
Warning
This unit is not FCC certified for use in a PDA.
Always eject card when not in use.
Locate the Antenna (Part Number MEA-Antenna12) and insert the
connector into the WMC6300 antenna port as shown in Figure 10.
Note: The connector will “snap” into place when fully inserted.
1.
Figure 10. Attach Antenna to the WMC6300
2. Locate the Antenna Clip shown in Figure 11 and remove the paper that
protects the adhesive backing.
Figure 11. Antenna Clip
3. Attach the Antenna Clip to the back of the laptop computer display
approximately 1 inch from the top corner of the display as shown in
Figure 12. Ensure that the location selected for the Antenna Clip will
reach the WMC6300 with the provided cable length.
Note: The antenna operational position must be greater than 8 inches or
20 cm from the bottom of the case and such that the Antenna is vertically
orientated when the laptop is in use.
9