User Manual

MeshNetworks
6
Connect the Antenna Assembly
Complete the following procedure to connect the Antenna Assembly to the
WMC6300..
1. Locate the Antenna and insert the connector into the WMC6300 antenna
port as shown in Figure 5.
Note: The connector will “snap” into place when fully inserted.
Figure 5. Attach Antenna to the WMC6300
Warning
Use only the MeshNetworks supplied antenna.
Use of another antenna is prohibited and violates FCC regulations.
Never use the WMC6300 with the Antenna disconnected from the Card.
Connect the Magnetic Antenna Assembly (Optional Equipment)
Complete the following procedure to install the Magnetic Mount Antenna on the
rooftop of a vehicle. (The cable length of the Antenna is approximately 12-feet.)
1. Attach the Magnetic Antenna to the metal rooftop of the vehicle so that
the antenna is in a vertical orientation.
Caution: The base of the antenna contains a powerful magnet that
secures the antenna to the rooftop. Use care when attaching the antenna
2. Route the remaining 12-foot cable as required to arrive at the Host
Computer.
Warning
Never use the WMC6300 with the Antenna disconnected from the Card.
3. Insert the Antenna Cable Connector into the WMC6300 antenna port as
shown in Figure 6. Note: The connector will “snap” into place when fully
inserted.