User's Manual
Table Of Contents
- 1 Introduction
- 2 Networking Basics
- 3 Installing Printer
- 4 Configuring the Printer
- Network Settings
- Configuring the Printer through the Operator Control Panel
- Configuring Wireless through the Printer Web Page
- Configuring Wireless through the Driver Toolbox
- Using ZXP Toolbox Wireless Settings Load/Save Buttons
- Using RADIO CONTROL Menu
- Using SET DEFAULTS Menu
- Simple Roaming Used During Connection
- Setting Up an Ad-Hoc (Peer) Network
- Multi-homing Considerations
- 5 Monitor Wireless Performance
- Wireless Info Pages
- Signal Strength
- Noise Floor
- Data Rate
- DHCP & MAC Address Info Page
- Wireless Statistics Info Page
- Wireless Statistics Success and Failure Rates
- Main Status Display Wireless Errors
- Viewing Wireless Information through Printer Web Page
- Viewing Wireless Information through Windows Printer Driver Toolbox
- 6 Troubleshooting
- 7 Technical Specifications
- 8 Glossary
- 9 Compliance Information
47
This screen provides some additional information not available through the OCP or printer web
page:
RSSI – received signal strength indicator. The strength of the received signal in dBm.
SNR – the signal to noise ratio in dB for the received signal.
Link lost – the number of times the connection to the access point has been lost.
Unicast packets – the number of unicast packets that have been sent or received.
Non unicast packets – the number of non unicast packets that have been sent or received.
Mcasttxframe - Increments when the multicast bit is set in the destination MAC address of a
successfully transmitted MSDU.