User's Manual

44
If the wireless interface is experiencing hard errors, an indication of this will be added to the
normal status display, such as the following:
A wireless error is not considered an alarm condition, such as “Out of Cards”, so the display
does not change to ALARM. The wireless error display is simply informative. In most cases
communications with the printer will have been lost, so the wireless error condition will not be
seen by a host. The wireless errors are detailed in the following table:
Wireless Error Text
Code
Description
WIFI ACCESS POINT
MISSING
19002 After power up, the printer tried to connect to the access point
specified by the wireless settings, but the access point was not
found during the scan. The printer will periodically retry to
connect to the access point.
WIFI LINK LOST 19003 The connection to the access point was lost. This may be due to
poor signal strength, interference or the access point power has
been lost. The printer will periodically retry to connect to the
access point.
WIFI INCOMPATIBLE
NETWORK
19004 After power up, the printer tried to connect to the access point
specified by the wireless settings, but found the access point
settings incompatible. This could occur if the access point
configuration is modified. To correct, re-run the Setup Wizard
to establish new wireless settings.
WIFI ASSOCIATION
FAILED
19005
During association with an access point, the association failed.
This could be a result of poor signal quality. If the signal
strength is low, take steps to improve it, then re-run the Setup
Wizard to establish new wireless settings.
WIFI CONNECTION
FAILED
19006 The key handshake following the association failed. This may be
because the WEP key or WPA passphrase is wrong. To correct,
make sure that you have the correct key passphrase then re-run
the Setup Wizard to establish new wireless settings.
READY
MENU INFO
READY
WIFI LINK LOST
ERROR CODE = 19003
MENU INFO